8.
The vertical louvers can be set to a direction or allowed to rotate through 120
o
by pressing the
SWING button.
9.
All the functions can be performed with the remote control supplied with this unit.
a)
Remove battery cover and install two “AAA” batteries (not included) as indicated. (Please
observe correct battery polarity.)
b)
Point the remote towards the unit and depress the appropriate button. The remote control
will operate up to 4 metres from the unit.
10.
Press the OFF button to cancel all functions.
11.
When not in use disconnect the unit from the power outlet and drain all water from the water
reservoir. (See HOW TO CLEAN)
NOTE: Initial setting is “normal” mode and “low” speed and will occur every time the plug is plugged into the
power main. Once the cooler has been set to desire function/s, the cooler will keep memory of the setting
as long as there is power to the cooler (step 2) when it is switched OFF, and without unplugging the power
plug. The cooler will only remember settings when main power which the cooler is plugged into, remains
switched on.
Care & Cleaning
To ensure effective humidifying and filtering, it is recommended that the filtering system be cleaned once
every 1-2 months.
1.
Disconnect the unit from the mains supply.
2.
Empty the water reservoir by loosening the plug of the water drainage outlet. Make sure you have a
container under the drain to collect the water or empty the unit outside. You may have to empty
the water collector a few times, so just re-cap the plug of the water drainage outlet during
emptying.
3.
It is important after every season to clean the water reservoir and filter system of the unit.
CAUTION: Care must be taken as the filter system contains electric cables and motor. These components
are not to be splashed or immersed in water.
4.
Unscrew rear fixing back cover screws and release the back cover.
