Assembly Instructions
Grills, fan blades and the main body of the fan are packed separately to protect your fan from damages
during transportation.
1.
Attach the column to the stand with the 4 screws as
shown.
2.
Unscrew and take off the height adjustment nut.
3.
Slide the stand cover down the column to rest on the
stand.
4.
Pull out the extension tube and refit the height
adjustment nut.
Caution:
The height adjustment screw must be fully
tightened before assembling the motor section to the
pedestal stand.
5.
Fit the motor section to the pedestal stand and tighten
the thumbscrew.
Caution:
The thumbscrew must be fully tightened before
the fan is operated.
6.
Remove the fibre glass sleeve from the shaft and unscrew the rear guard retaining nut by turning it
counter-clockwise until tight.
7.
Set the rear guard in the proper position (handle uppermost) and screw on the guard retaining nut
until tight.
8.
Install the blade onto the shaft and screw on the blade retaining nut (counter-clockwise) until tight.
9.
Open clips on the front guard and place front guard onto rear guard (align locking screw holes) and
close clips.
10.
Secure both guards firmly by fitting and tightening the locking screw and nut.
Before First Use
Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
Operating Instructions
Before inserting the plug into a power outlet, make sure that the correct voltage being used corresponds to
what is indicated on the rating label, and that the socket has an earth facility.
1.
Turn the Speed Control knob for the required fan speed: ‘0’ for ‘OFF’, ‘1’ for Low Speed, ‘2’ for
Intermediate Speed and ‘3’ for High Speed.
2.
To make the fan head oscillate, push the oscillating knob DOWN. To stop the oscillation, pull the
oscillating knob UP.
3.
To adjust the tilt of the fan head, simply tilt the fan head to the desired angle. The head can latch in
one of three positions.
CAUTION:
The fan should be switched off when making this adjustment.
NOTE:
The head will not latch into the low or mid position until the guard and blade are fitted to the motor.
4.
To adjust the height of the pedestal fan, loosen the eight adjustment screw carefully raising or
lowering the fan and firmly re-tighten the height adjustment nut.
CAUTION:
The fan should be switched off when making this adjustment.
