US
DE
Automation Instructions CPK • 10-2015 •106-29009
Installation
18
5 .4 Installing the accessories
5 .4 .1 Installing the deflector hanger CPK
2
1
1
f
From the front, set deflector hanger
2
on the tool and
from the side, secure it with screw
1
.
;
The deflector hanger is seated on the tool.
5 .4 .2 Installing the bandoleer cutter CPK
NOTE
The bandoleer cutter CPK and the overhead suspension
CPK use the same means of attachment to the tool, which
means that they cannot be used together
.
1
2
4
3
f
Slacken screws
4
in tool
3
and remove the screws.
f
Insert fitting adapter of bandoleer cutter
1
into the
groove in the tool.
f
Insert screws
4
and tighten.
f
Connect the compressed-air supply to pneumatic
cylinder
2
of the bandoleer cutter CPK,
5 .5 Positioning
5 .5 .1 Positioning the material for bundling
f
Make sure that the material for bundle is always in the
same position.
f
Bundle the material neatly. Make sure there are no
projecting cable-tie ends.
f
Make sure that the top and bottom jaws of the tool are
not obstructed.
15°
f
Tilt the tool at an angle of 15 ° relative to the material to
be bundled. The bench mount kit CPK holds the tool at
the correct angle of inclination.
90°
10 mm
f
Guide the tool past the material to be bundled at an
angle of 90 ° to ensure that each binding is secure
without projecting cable-tie ends.
f
Make sure that the cable ties are set with a minimum
spacing of 10 mm.
NOTE
If the material to be bundled is held rigidly (e.g. metal tubes),
the tool has to be spring-mounted to ensure correct binding.
5 .5 .2 Installing the stand-off HH20
f
When installing the stand-off HH20, note the geometry
of the tool.
;
This permits collision-free movement of the tool and
clean cable-tie cut-off.
Summary of Contents for Autotool 2000 CPK
