HellermannTyton Autotool 2000 CPK Automation Instructions Download

Page: 5 / 72

Automation Instructions CPK • 10-2015 •106-29009

Notes for the user

1 Notes for the user

These instructions are very important for correct installation
of the device in automatic systems. They contain important
information and safety instructions that will enable you
to install the product properly and utilize it correctly and
economically for its intended use.

1 .1 Information about these instructions

Use these instructions only together with the Operating
Instructions of the AT2000 CPK.
Last update: 22.12.2015

1 .2 Warranty

The warranty is in accordance with statutory requirements.
Warranty entitlement applies only in the country in which
the products were originally purchased. Batteries, fuses and
light sources are not covered by the warranty.

1 .3 Contact data

The manufacturer of the product described in these
instructions is:
HellermannTyton GmbH
Grosser Moorweg 45
D-25436 Tornesch, Germany
Tel. +49(0)41 22/70 1-0

www.HellermannTyton.de
toolsystems@HellermannTyton.de

1 .4 Copyright and intellectual property rights

The manufacturer retains the copyright to these instructions.
Under no circumstances may these instructions be reproduced
or electronically processed, replicated or disseminated,
in whole or in part, without the prior written consent of
HellermannTyton GmbH (hereinafter referred to as
HellermannTyton).
Any breach or infringement of these stipulations will result in
liability for damages.

1 .5 Keeping and dissemination of these

instructions

These instructions must be kept in the immediate vicinity of
the workplace and must be available at all times to all
operating personnel. The operating company shall inform
the operating personnel of the location of these instructions.
The operating company shall obtain replacement from the
manufacturer if these instructions are, become or are
rendered no longer easily legible.
If the products are acquired by or sold on to a third party the
following documents must be handed over to the new owner:
•  These instructions
•  Documents relating to repair work
•  Logs of repair work undertaken

1 .6 Target group of these instructions

These instructions must be read and complied with by every
person charged with any of the following tasks:
•  Assembly
•  Operation
•  Servicing
•  Repair
•  Fault rectification

1 .7 General information

All accompanying drawings are not covered by the change
service.

1 .8 Conventions adopted in these instructions

1 .8 .1 Classification of the precautionary notices

Precautionary notices in these instructions draw attention to
hazards associated with use of the device and indicate how
they can be avoided.
Non-compliance of any nature whatsoever can lead to acci-
dents with fatal consequences, injury or damage to property.
The precautionary notices are subdivided into three groups
according to the severity of the potential hazard:

DANGER

Texts accompanied by the signal word "DANGER" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, will cause death or
severe injury.

WARNING

Texts accompanied by the signal word "WARNING" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause serious injury.

CAUTION

Texts accompanied by the signal word "CAUTION" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause slight injury.

1 .8 .2 Other notational conventions

Indicates an instruction

• Indicates an item in a bulleted list

;

Indicates the result of an action

This text highlight

is used for cross-references.

NOTE

Texts accompanied by the signal word "NOTE" indicate
situations which, in the event of non-compliance with the
appropriate precautions, can cause damage to the tool or
the product.

Texts accompanied by this symbol contain information about

environmental protection.

Texts accompanied by this symbol contain useful additional

information.