US
DE
Automation Instructions CPK • 10-2015 •106-29009
Safety warnings
6
2 Safety warnings
2 .1 General power tool safety warnings
The safety warnings in the Operating Instructions for the tool
also apply to operation of the tool after installation of an
automation system or device.
WARNING
Non-compliance with the safety warnings below can lead
to sever injuries, fire and electric shock .
f
Comply with the instructions and warnings below.
f
Keep the Operating Instructions for the tool ready to
hand.
2 .2 Intended use
Use the apparatus only when it is in full working order and
safe, always be safety-conscious and aware of the hazards.
The apparatus with integrated AT2000 CPK is suitable for
and intended for the following uses:
• Automatic binding of bundles up to a diameter of max.
20 mm
• For indoor use only
• Industrial use
2 .3 Misuse
Use other than as stated in the section entitled "Intended
use" is misuse. The operating company responsible for use of
the apparatus bears sole responsibility for injury and damage
resulting from misuse.
The safety regulations for the AT2000 CPK (see the Operating
Instructions for the tool) apply additionally.
The following are specifically prohibited:
• Use with faulty parts
• Use in explosive environments or in the presence of a
fire hazard
• Use outdoors
• Use in high humidity and/or direct sunlight
• Manipulation while processes are in progress
• Unauthorized alterations and modifications to the
apparatus and its component parts without the prior
consent of HellermannTyton
• Use of spare parts and accessories not tested and
approved beforehand by HellermannTyton
2 .4 Personnel qualification
Under-age persons and trainees are permitted to use the
device only under the supervision of an experienced specialist
and only with the express permission of the operating
company.
2 .4 .1 Specialist personnel for operation
The tasks and authorizations assigned to specialist personnel
for extended operation are as follows:
• Operation of the products
• Rectification of faults or, as applicable, initiation of
measures for the rectification of faults
• Cleaning of the products
These individuals have the specialist training or practical
experience that will ensure correct handling.
2 .4 .2 Specialist personnel for maintenance and
servicing
Always have maintenance and servicing carried out by duly
qualified specialist personnel. These individuals have the
specialist training that affords sufficient knowledge of the
tool or product for them to judge when it is in safe working
order.
These individuals are also familiar with the following rules
and regulations:
• Applicable national health and safety regulations
• Accident prevention regulations
• Generally accepted codes of practice, regulations and
standards
2 .4 .3 Authorized person for low-voltage electrical
equipment
Always have work on the electrical supply and on parts that
are live when the device is in operation carried out by a
person duly authorized to work on low-voltage electrical
equipment.
2 .4 .4 Authorized specialist for repair and testing
Only service technicians from HellermannTyton or service
technicians authorized by HellermannTyton are permitted to
carry out repairs and safety checks.
Summary of Contents for Autotool 2000 CPK
