Hello Kitty Hello Kitty KT2054, Owner'S Manual

POWER SOURCE

This product operates on 120VAC/60Hz household electrical outlet

voltage. For clock memory back-up you need to install one 9V battery

(not included) to the battery clip located inside the Battery

Compartment (#4). The battery helps retain the time and alarm settings

in memory in the event of a power outage, but will not display it on the

Clock Display (#7). Normal display and functions will resume when the

power is restored. We recommend checking and/or replacing the

battery every one to three months. If the battery is weak, replace it

immediately. For maximum performance we recommend using a good

quality battery (such as Eveready type 6F22 or equivalent).

RADIO OPERATION

1.  Set the ON/AUTO/OFF Switch (#6) to “ON” position.

2.  Set the AM / FM Band Selection Switch (#11) to desired band.

3.  Tune to the desired station with Tuning Control (#10).

4.  Adjust the volume level with Volume Control (#12).

5.  For best FM reception, fully extend the FM Antenna Wire. For best

  AM reception, try turning the unit slowly until the best station

  reception is obtained.

6.  The radio can be switched off by setting ON/AUTO/OFF Switch (#6)

  to the “OFF” position.

Note:

 Do not connect the FM Antenna wire to any other external

antenna.

SETTING THE CLOCK TIME

1.  Set the Clock Setting Switch (#5) to the time set position. The 2 dots

  between the hour and minutes will begin flashing.

2.  Rotate the Rotary Set Dial (#8) counterclockwise for adjusting the

  current minute or clockwise for adjusting the current hour.

3.  A “PM” Indicator (#19) is located on the LED Clock Display (#7) in the

  upper left-hand corner. The time will be in the “AM” range when the

  “PM” indicator is not lit. It is important that the "AM" or "PM" setting is

  correct for proper operation of the alarm function.

4.  Once the time is adjusted, set the Clock Setting Switch (#5) to the

  “RUN” position. The 2 flashing dots will stop flashing.

P5