Hello Kitty KT2029BT, User Manual

 E-4

COMPLIANCE WITH FCC REGULATIONS 

FCC ID KKI-F-6088 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
(1)    This device may not cause harmful interference, and 

(2)    This device must accept any interference received, including interference that may cause 

undesired operation. 

This equipment has been tested and found to comply with the limits for a Class B Digital Device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures: 
 

- 

Reorient or relocate the receiving antenna. 

- 

Increase the separation between the equipment and receiver. 

-  Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

- 

Consult the dealer or an experienced radio/TV technician for help. 

WARNING 
Changes or modifications to this unit not expressly approved by the party responsible for 
compliance could void the user's authority to operate the equipment. 

PROTECT YOUR FURNITURE!! 

 
This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you 

operate the controls. These ‘feet’ are made from non-migrating rubber material specially formulated 

to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture 

polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and leave 

marks or a rubber residue on the furniture.   

To prevent any damage to your furniture we strongly recommend that you purchase small 

self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, 

and apply these pads to the bottom of the rubber ‘feet’ before you place the product on fine wooden 

furniture.