Helmer Scientific i.Series
®
and Horizon Series
™
Freezer - Undercounter
Service and Maintenance Manual
360417/A
11
2.6 Configure Storage
Notes
• Before moving storage components, protect stored items in freezer from extended exposure to adverse temperature.
• Before moving drawers or shelves, ensure they are completely empty for safe lifting.
• Maximum drawer or shelf load is 100 lbs (46 kg).
Product Loading Guidelines
Note
Products stacked against the back wall may obstruct air flow and affect performance of the unit.
When loading your freezer, take care to observe the following guidelines:
♦
Never load the freezer beyond capacity.
♦
Always store items within shelves or drawers.
♦ Temperature uniformity is maintained by air circulation, which could be impeded if the unit is overfilled, particularly at
the top or back. Ensure a minimum of 2” (50 mm) clearance is provided below the fan.
Drawers
Remove Drawer
1. Pull the drawer out until it stops.
2.
Lift the front of the drawer off the front rollers on the slide.
3. With the front of the drawer slightly lifted, pull the drawer all the way forward. The rear drawer rollers should be touching
the front slide rollers.
4. Lift the drawer to free from the slides.
Install Drawer
1. Align the rear rollers on the drawer with the opening just behind the front slide rollers.
2. Place the rear drawer rollers on the slides and gently push the drawer into the chamber until it stops.
3. Pull the drawer out until it stops to check for smooth operation.
Move Drawer Slides
1. Using a screwdriver, remove the bracket retainers.
2. Tap the brackets upward to disengage from standards.
3. Remove the slides from the standards.
4. Insert the slides into the standard at the appropriate height.
5. Tap the brackets downward to engage with standards.
6. Using a screwdriver, install the bracket retainers.
i.Series
