Helmer Scientific i.Series
®
and Horizon Series
™
Refrigerator - Pass-Thru
Service and Maintenance Manual
360429/A
11
2.5 Configure Storage
NOTICE
• Ensure drawers or shelves are completely empty before moving.
• Maximum drawer or shelf load is 100 lbs (46 kg).
Note
Before moving storage components, protect stored items in refrigerator from extended exposure to adverse temperature.
Product Loading Guidelines
When loading your refrigerator, take care to observe the following guidelines:
♦
Never load refrigerators beyond capacity.
♦
Always store items within shelves or drawers.
♦ Temperature uniformity is maintained by air circulation, which could be impeded if unit is overfilled, particularly at the top or
against the walls. Ensure a minimum of 2” (50 mm) clearance is provided below the fan.
Note
Products stacked against walls may obstruct air flow and affect performance of unit.
Drawers
Remove Drawer
1. Use a #2 Phillips screwdriver to remove screw from each of four retaining clips (total 4 screws).
2. Use a #2 Phillips screwdriver to remove all screws (total 8) securing each of four drawer brackets to drawer nutserts.
3. Lift up and angle drawer to remove from refrigerator.
Install Drawer
1. Place brackets in desired location and install drawer at an angle setting loosely on drawer brackets.
2. Line up drawer nutserts with slots on drawer brackets and use a #2 Phillips screwdriver to loosely install screws.
3. Adjust location of drawers as necessary and use #2 Phillips screwdriver to tighten screws.
4. Install retainer clips and use #2 Phillips screwdriver to tighten screws.
Move Drawer Slides
1. Using a #2 Phillips screwdriver, remove all bracket retainers.
2. Tap slide brackets upward to disengage from standards.
3. Remove slides from standards.
4. Insert slides into standard at appropriate height.
5. Tap slide brackets downward to engage with standards.
6. Using a #2 Phillips screwdriver, install bracket retainers.
i.Series
