360142-D/D
38
i.Series® Models
8.6.1
Remove the Unit Cooler Cover
1
Switch AC ON/OFF switch OFF. Switch battery switch OFF.
2
Remove the rear protective cover (G) on the rear of the cabinet.
a
Loosen four screws
b
Slide the cover up and remove
c
Cut the wire ties securing the drain line to the cabinet
3
On the back of the cabinet, peel the putty back to expose the drain tube (H) and drain heater (E).
!
CAUTION
The condensate evaporator and water evaporation tray are hot.
4
Inside the cabinet, remove the putty around the drain tube.
5
Remove the wire ties securing the heater wires (F) to the cabinet. Verify the heating element is cool.
6
Remove the drain heater from the drain tube.
7
Remove the drain tube (H) by pulling it downward. The drain tube should separate from the fan tube
(D) at the 90° elbow, leaving the fan tube (D) attached to the fan (C).
a
The section of the drain tube inside the cabinet should separate from unit cooler drain port (B).
b
Gently twist the drain tube from left to right to separate it from the unit cooler drain port.
c
Pivot the drain tube upward then remove it from the cabinet.
8
Remove top drawer, basket, or shelf from the chamber.
9
Remove the unit cooler cover (A).
a
Hold unit cooler cover in place to prevent it from dropping.
b
Use the socket wrench to remove four screws securing the unit cooler cover.
c
Carefully lower unit cooler cover to avoid damage to the fan wiring.
8.6.2
Install the Unit Cooler Cover
1
Verify unit cooler wiring is connected and routed correctly.
a
Wiring should be routed above copper tube inside the unit cooler.
b
Reconnect wires if they have separated.
2
Attach unit cooler cover.
a
Lift unit cooler cover into place.
b
Front edge of the cover should be behind the unit cooler case.
c
Use the socket wrench to install four screws to secure the unit cooler cover.
3
Insert the drain tube through hole in the cabinet.
a
Push drain tube upward at an angle, toward the unit cooler drain port.
b
Picot the drain tube downward then push the tube upward.
c
In the chamber, push the drain tube onto unit cooler drain port.
4
Attach the drain tube to the fan tube.
5
Insert the drain line heater in the drain tube.
a
Insert the heater at an upward angle.
b
The black heating element should no longer be visible.
6
Reinstall top drawer, basket, or shelf if previously removed.
7
Reattach the drain line heater wires to the cabinet.
8
On the back of the cabinet, press putty around the drain hose and partially into the hole.
9
Install the protective cover on the rear of the cabinet.
10
Switch AC ON/OFF switch ON. Switch battery switch ON.
11
Touch
Mute
to disable the high temperature alarm while freezer reaches operating temperature.
