360142-D/D
68
Horizon Series™ Models
10
Install the hinge spring and pin assembly.
a
Close the door.
b
Assemble the hinge spring assembly for the left side of the door
(Figure A)
.
c
Orient the bend in the coil toward the front of the freezer
(Figure B)
.
d
Slide the internal hex cap (with washer) on to the upper hex bolt in the lower hinge.
B
A
Washer
Internal
hex cap
Pin
Spring
Spring cap
Bushing
e
Use a J-hook tool in the spring cap to compress the spring upward
(Figure C)
.
f
While compressing the spring, slide the spring cap over the lower hex bolt in the lower hinge
(Figure D)
.
D
C
g
Use a J-hook tool to engage the right-most hole in the spring cap and rotate the spring cap from
right to left,
and hold.
h
Count four holes, starting from and including the spring cap hole closest to the end of the coil.
i
Insert the pin in the fourth hole.
Rotate the spring using a J-hook tool then insert pin (left-hinged door shown).
11
Switch AC ON/OFF switch ON. Reconnect the battery.
12
Close the lower front control panel.
