360142-D/D
61
Horizon Series™ Models
Remove a shelf
1
With one hand, lift front edge of the shelf from the front brackets.
2
With the other hand, reach under the shelf and bump rear edge of the shelf upward to disengage rear brackets.
Install a shelf
1
Insert shelf into chamber, placing it on brackets.
2
Gently bump rear edge of the shelf downward to engage brackets.
3
Pulling shelf forward gently; shelf should not disengage from rear brackets.
12.5
Move slides and brackets
Remove Drawer Slides
1
Using a screwdriver, remove front bracket retainers.
2
Tap front brackets upward to disengage standards.
3
Remove slides from standards.
Install drawer slides
1
Insert slides into standard at appropriate height.
2
Tap front brackets downward to engage standards.
3
Using a screwdriver, install front bracket retainers.
Remove shelf brackets
1
Using a screwdriver, remove front bracket retainers.
2
Tap front brackets upward to disengage standards.
3
Remove front brackets from standards.
Install shelf brackets
1
Insert front brackets into standard at appropriate height.
2
Tap front brackets downward to engage standards.
3
Using a screwdriver, install front bracket retainers.
12.6
Level the Freezer
NOTE
►
Leveling feet are optional.
►
Helmer recommends the use of leveling feet
(unless casters are installed) and wall
and floor brackets (PN 400472-2) for stabilization. Contact Helmer Technical Service
for parts and instruction.
►
A bubble level may be used to ensure the freezer is level.
Leveling feet must be adjusted to provide unit cooler drainage.
Front-to-back
1
Using a wrench, raise or lower leveling feet.
2
When freezer is properly leveled, bottom of the unit cooler will slope downward from front to back
(toward the condensate drain line).
Side-to-side
1
Using a wrench, raise or lower leveling feet.
2
When freezer is properly leveled, bottom of the unit cooler will be horizontal (parallel to the floor).
12.7
Optional Adapter Kits for Medication Dispensing Locks
Contact Helmer Technical Service or your distributor for service documentation pertaining to medication
dispensing locks.
