Helmer Scientific Platelet Agitator
Service Manual
360391/A
4
Symbols found on the units
The following symbols may be found on the agitator or agitator packaging:
0086
CE Mark (European units only)
Earth / ground terminal
Caution: Risk of damage to equipment or
danger to operator
Protective earth / ground terminal
Caution: Hot surface
Product falls under the scope of the WEEE
(Waste Electrical and Electronic Equipment)
directive.
Caution: Shock / electrical hazard
1.5
Avoiding Injury
Review safety instructions before installing, using, or maintaining the equipment.
♦
Before moving unit, remove contents from the drawers.
♦
Do not open multiple drawers at the same time.
♦
Before moving unit, disconnect the DC power cord and secure the cord.
♦
When moving unit, use assistance from a second person.
♦
Never physically restrict any moving component.
♦
Avoid removing electrical service panels and access panels unless so instructed.
♦
Keep hands away from pinch points when agitation motion is enabled.
♦
Avoid sharp edges when working inside the electrical compartment.
♦
Ensure biological materials are stored at recommended temperatures determined by standards, literature, or good
laboratory practices.
♦
Proceed with caution when adding and removing samples from the platelet agitator.
♦
Use only manufacturer supplied power supply/cord when operating stand-alone or within incubator.
♦ Using the equipment in a manner not specified by Helmer Scientific may impair the protection provided by the equipment..
♦ The platelet agitator is not considered to be a storage cabinet for flammable or hazardous materials.
CAUTION
Decontaminate parts prior to sending for service or repair. Contact Helmer Scientific or your distributor for
decontamination instructions and a Return Authorization Number.
