360094-1/M
7
Operation
Section II: Operation
8
General Operation
8 .1
Initial Start Up
1
Plug the power cord into a grounded outlet that meets the electrical requirements on the product
specification label.
2
Press the AC ON/OFF button to power the plasma thawer
ON
.
NOTE
►
The AC ON/OFF switch also controls the fan on 100 V DH8 models.
►
High temperature alarm activates quickly when chamber is empty.
8 .2
Fill the Chamber
Two fill lines are marked on the rear wall of the chamber. The lines indicate the maximum water level for
the following applications:
►
Upper line:
maximum level for thawing random bags
►
Lower line:
maximum level for thawing apheresis bags
Chamber fill lines.
NOTE
►
Determine the type of water to be used (tap or distilled), according to your
organization’s requirements.
►
Use of a bacterial growth inhibitor, such as Helmer CleanBath, is recommended.
►
Do not use deionized water as it may be corrosive to the chamber and baskets.
Add water to the chamber:
1
Ensure the chamber and drain are free of debris or contaminants.
2
Ensure the drain tube is not connected.
3
Fill the chamber to the appropriate level.
4
Add bacterial growth inhibitor (optional).
