Ensure the HE-HLS01 is Powered On and the LED indicator blinks red slowly (i.e. it is
excluded).
Start the Inclusion Mode from the gateway/controller.
To start the inclusion process on the HE-HLS01:
a) if you want to use the device as a relay (binary switch), double-press the service
button on the device (with no more than a one-second interval between presses).
b) if you want to use the device as a thermostat, press four times the service button on
the device (with no more than a one-second interval between presses).
The LED indicator will blink green quickly.
If the inclusion has been successful, the LED indicator will turn green for three seconds
then continue slowly blinking green continuously while the HE-HLS01 is Powered On.
If the inclusion was not successful, the LED indicator will turn red for three seconds
then continue slowly blinking red continuously while the HE-HLS01 is Powered On. In
that case repeat the inclusion process (2-5) above.
Ensure the HE-HLS01 is Powered On and the LED indicator blinks green slowly (i.e. it is
included in a Z-Wave network).
Start the Exclusion Mode from the gateway/controller.
To start the exclusion process on the HE-HLS01, double-press the service button on the
device (with no more than a one-second interval between presses).
The LED indicator will blink red quickly.
If the exclusion has been successful, LED indicator will turn red for three seconds then
continue slowly blinking red continuously while the HE-HLS01 is Powered On.
If the exclusion was not successful, the LED indicator will turn green for three seconds
then continue slowly blinking green continuously while the HE-HLS01 is Powered On.
In that case repeat the exclusion process (2-5) above.
Note:
If the HE-HLS01 has previously been part of a Z-Wave network and not Excluded
since, Inclusion is not possible without first performing an Exclusion or Factory Reset
procedure.
Including the HE-HLS01 to an Existing Z-Wave Network
To add the HE-HLS01 to an existing Z-Wave network (i.e. “inclusion”), do the following:
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
Removing the HE-HLS01 from Z-Wave network
To remove the HE-HLS01 from a Z-Wave network (i.e. “Exclusion”), do the following:
9
Summary of Contents for HE-HLS01
