11
Associations
Association enables the HE-HT01 to control other Z-Wave devices over the network. Association Group may control other
devices from different brands and/or manufacturers. The HE-HT01 has two association groups:
Group 1
–
“Lifeline”:
reports full state of the device and used to communicate with the Z-Wave gateway. Max
supported nodes: 1
Note:
It is not recommended to modify this group.
Group 2
–
“Basic Set On/Off: Relay”:
is assigned to the HE-HT01 operating state. It sends a Basic Set command with
value 0 (Off) when it goes to IDLE state and sends 255 (ON) when it goes into HEATING state. Max supported nodes: 1
Settings Menu
To enter the Settings Menu, press and hold the
Gear “
” button for three seconds.
The abbreviated Parameter
Name
will be displayed in the bottom left corner of the LCD. The top left corner will display the Parameter
Number
. And the top
right corner will display the Parameter
Value
.
To
scroll through the menu, press the Heating Element “
” button to go up and the “
MODE
”
button to go down.
To change the Parameter value, press the Plus “
+
” or Minus “
–
” buttons.
To leave the Settings Menu press and hold the “
”
button for 3 seconds or just wait. If no action is detected for 20
seconds the display will automatically revert to the main display mode.
Settings (available through menu and Z-Wave network)
All configuration parameters are accessed through Z-Wave COMMAND_CLASS_CONFIGURATION
Group
Number
Name
Description
Default
Value
Value Range
01
Г
Eg
Frequency Region
EU:
Europe
US:
USA
AU:
Australia
HO: Hong Kong
In:
India
IL:
Israel
Г
U:
Russia
Cn:
China
JP:
Japan
O
г
: Korea
02
nEt
Inclusion / Exclusion Mode
InC, ECL
03
HS
Hardware and Firmware Versions
Read Only
04
LPc
Energy Consumption, kWH
Load Power, kW
Read Only
