Start the Inclusion Mode from the gateway/controller.
To start the inclusion process on the HE-TPS01, simultaneously press the two upper hidden touch buttons (see Figure 6) and hold them
for three seconds.
The button will then sequentially blink ‘blue-red’.
If the inclusion has been successful, the button will turn blue for three seconds.
If the inclusion was not successful, the button will turn red for three seconds. In that case repeat the inclusion process.
Start the Exclusion Mode from the gateway/controller.
To start the exclusion process on the HE-TPS01, simultaneously press the two upper hidden touch buttons (see Figure 6) and hold them
for three seconds.
The button will sequentially blink blue-red.
If the exclusion has been successful, the button will turn red for three seconds.
If the exclusion was not successful, the button will turn blue for three seconds. In that case repeat the exclusion process.
Note:
If the HE-TPS01 has previously been part of a Z-Wave network and not Excluded since, Inclusion is not possible without first
performing an Exclusion or Factory Reset procedure.
Including the HE-TPS01 to an Existing Z-Wave Network
To add the HE-TPS01 to an existing Z-Wave network (i.e. “inclusion”), do the following:
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Removing the HE-TPS01 from Z-Wave network
To remove the HE-TPS01 from a Z-Wave network (i.e. “Exclusion”), do the following:
