THERMOSAT OVERVIEW & OPERATING INSTRUCTIONS
This is a programmable electronic room thermostat for flush mounting into most standard wall boxes. It is
designed to maintain a constant ambient temperature, the criteria of which can be simultaneously either
floor, room or both sensors.
It is recommended for the control of electric heating devices (radiators/convectors) or electric under floor
heating. The heating element is directly controlled by a single pole switch. The maximum loading for the
thermostat is 16A over which a contactor will be required. (16A – 3600W @ 220/240V.)
The thermostat has a LCD screen, four sensitive capacitive touch control buttons and two temperature
sensors (external NTC floor sensor and a built-in room air temperature sensor). The thermostat is also
equipped with built-in humidity and energy consumption sensors.
The thermostat has a built-in 5
th
generation Z-Wave module which allows to integrate the device to Z-Wave
Home Automation systems such as Fibaro, Vera, Zipato and others. The thermostat can be connected with up
to 10 Z-Wave devices (relays, switchers etc.)
One of four operation modes can be selected either manually or via the Z-Wave controller. The 4 operating
modes are: DRY - floor quick drying mode, ECO – energy saving mode, GEN - general (most comfortable) mode
and manual mode. The thermostat protects the floor from overheating by automatically switching off the load
when the temperature reaches a maximum of 40°C.
The LCD screen with white icons has a user-friendly interface, displaying:
floor temperature, air temperature, humidity level, user set temperature, operating mode, relay and Z-Wave
network status.
