3
iDim
Doc No: 7860263
A
C
Helvar
Helvar
B
A
Helvar
Helvar
Data is subject to change without notice. More information at: www.helvar.com
Setup iDim Remote Cradle for Wall Attachment
To mount the iDim Remote Cradle to a wall:
1. Drill and insert screw to chosen mounting location.
Leave approx 1 mm between screw head and wall to
allow cradle to sit comfortably on screw.
2. Carefully slide the cradle onto the screw adjusting
screw tightness as required.
3. With cradle still wall mounted, mark hole A on the wall.
4. Remove cradle, drill second hole and apply wall plug
5. Slide cradle back on to wall and insert bottom
screw. Tighten screw as needed.
To attach the iDim Remote to the remote cradle:
1. Place iDim Remote onto cradle mounting point.
2. Push iDim Remote downwards until it clicks, holding the
unit in place.
Note: Remove the iDim remote by following the above
procedure in reverse.
Attach iDim Remote to Cradle
Assemble iDim Remote Cradle for Desktop Use
To assemble the iDim Remote Cradle for desktop use:
1. Attach rubber feet A to base B.
2. Insert base B into recess C on the reverse of the
cradle until it clicks.
To disassemble the iDim Remote Cradle (not shown):
3. Insert fl at head screwdriver into recess C and gently
lever base A away from the cradle to avoid the unit
being damaged.
Add / Remove Batteries
To add or remove batteries:
1. Unclip the battery cover on the reverse of the remote.
2. Add batteries, observing correct polarity and replace
cover.
Note: Batteries not required if running iDim Remote Control
through a PC via USB cable.
