5
iDim
Doc No: 7860263
1%
DALI 1
1%
100%
100%
4
O
5
6
7
1
2
3
Ch
Ch
1%
DALI 2
1%
100%
100%
4
O
5
6
7
1
2
3
Ch
Ch
CLASS-
ROOM
SINGLE
OFFICE
OPEN PLAN
OFFICE
CORRIDOR
LINK
CORRIDOR
HOLD
MEETING
ROOM
iDim
Controller
Scene 1
DALI 1
CL
CL
CL
FL (100%)
CL
CL
DALI 2
Offset
Offset
Offset
FL (100%)
Link to
Corridor
1
See notes
below
2
iDim
Controller
Scene 2
DALI 1
CL
CL
CL
FL (70%)
CL
-
DALI 2
Offset
Offset
Offset
FL (70%)
Link to
Corridor
FL (100%)
iDim
Controller
Scene 3
DALI 1
FL (100%) FL (100%)
FL (100%)
FL (40%)
FL (100%)
-
DALI 2
FL (100%)
FL (100%)
FL (100%)
FL (40%)
Link to
Corridor
FL (0%)
iDim
Controller
Scene 4
DALI 1
FL (40%)
FL (40%)
FL (40%)
FL (10%)
FL (40%)
FL (40%)
DALI 2
FL (40%)
FL (40%)
FL (40%)
FL (10%)
Link to
Corridor
FL (20%)
Data is subject to change without notice. More information at: www.helvar.com
To modify light levels using the iDim remote:
1. Point the remote at a controller.
2. Select the scene you wish to modify.
3. Press DALI 1 modifi er key up to raise DALI 1 light level.
4. Press DALI 1 modifi er key down to lower DALI 1 light level.
6. Press DALI 2 modifi er key up to raise DALI 2 light level.
7. Press DALI 2 modifi er key down to lower DALI 2 light level.
Note 1: If you intend to store the modifi ed levels, ensure the
required scene number is selected before modifying.
Note 2: Scene 1 is the default ’on’ scene selected by PIR
movement and Solo SW1 and SW2.
Note 3: When operating in Constant light + Offset mode, the
DALI 1 and DALI 2 levels will both adjust together.
Table 1:
Default DALI 1 and DALI 2 Constant Light, Fixed Light and Offset confi guration for the six default iDim modes.
1
In Corridor Hold (iDim Mode 5) DALI 2 is only used to connect an offi ce to the corridor.
2
In Meeting Room (iDim Mode 6), iDim Solo SW1 input operates DALI 1 CL / Off and SW2 input operates DALI 2 FL (100%) / Off;
as SW1 is located at the entrance of a room, switching off SW1 will cause both DALI 1 and DALI 2 circuits to go off.
When modifying the constant light target levels for your system, please ensure that the process is done in a darkened room or
during dusk as excessive natural light may result in levels being recorded by the sensor that are not actually achievable.
Table Information
: In this table ‘iDim Controller’ refers to iDim Remote, Switches and Panels unless specifi ed.
Modify Light Levels using iDim Remote