10
Data subject to change without notice. For more information visit our website: www.helvar.com
Set PIR ON scene
• Simultaneously press & hold “
0/1
” &“ ” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Set PIR LOW scene
• Simultaneously press & hold “
0/1
” & “ ” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Set PIR OFF scene
Select the overall desired light level: -See Infrared (IR) control section.
• Simultaneously press & hold "
0/1
” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Note:
This also sets the Constant light level
Select the overall desired light level: -See Infrared (IR) control section.
Notes:
• Regardless of other light level commands (e.g. changes in the constant light level), an enabled
PIR will switch the lights to the
PIR OFF
scene if no movement is detected within its programmed
delay time.
• PIR scenes can be any combination of light levels of channels A & B.
Presence detector (PIR)
Select the overall desired light level: -See Infrared (IR) control section.