Quick Installation Guide
Document
WERA4-Quick-US-200917
Page 56 of 73
For a description of most of the parameters see the description of WeraDesk in the
previous chapter.
The plot in the frequency management section displays an average of the external
noise measured during the last frequency pre-scan.
The last line shows the status of the measurement cycle on the left side and the status
of automatic cycles (by crontab) on the right side.
"Close This Window" closes the status page, which can be re-opened from the
WeraDesk main page.
If the web browser caches the graphics, the web page might need to be updated
manually to reload the frequency pre-scan graphics. For the Firefox and Internet
Explorer web browsers this can be done by pressing the “F5” key.
7.3
WERA Status overview
On each WERA UPC the results of regularly processed measurement can be viewed
via web. These pages can be accessed via the start page of WERA Control Center.
To display the start page on the UPC, enter the URL http://localhost/~wera/ .
To access this page over the internet, replace “localhost” with the ip adress of the
UPC.
An overview of the last processed measurement results can be obtained, if you click
on “Latest WERA results”.
An overview of all processed results can be reached with a click on “WERA status
overview”, this will open a list of directories, coded by the day.
In these directories are sub-directories for the time, coded in hour and minutes of
acquisition time.
