5. Assemble the Drawers
Safety Information
Wall Mounting
Desk Mounting
Stacking
.
Affix two runners to each of the top 7 drawers as shown.
Any three screw holes can be used to attach each runner,
but avoid placing screws near the nails already in the
panel. As the holes are not pre-drilled, using a drill or
electric screwdriver is recommended. Ensure the runners
are positioned firmly against the front and side of the
drawer.
WARNING: If the thread cabinet is not mounted or anchored
securely, it could topple forward and cause serious injury.
Ensure it is fastened before use.
For your safety, it is essential that the finished cabinet is securely
anchored to a wall or sturdy desk before being filled with thread.
Follow the appropriate mounting instructions below for your
situation, or consult your local hardware store for alternatives.
When full with thread the
cabinet can weigh up to 100 lbs.
It can be hung on a wall using
the included wall mount panel.
It is strongly recommended
that wall mounting should only
be attempted by an
experienced tradesperson.
The Wall Mount (W) panel
should be secured
horizontally in the desired
location, ensuring it is level
and facing the wall as shown.
It is essential that the panel is
screwed firmly into the wall
frame or an otherwise solid
wall - plasterboard alone will
not support the weight of the
cabinet.
Note: the supplied wall plugs are for solid walls only and must
not be used on plasterboard
The cabinet can now be hung from the Wall Mount panel. For
extra stability, the included safety bracket can be used to anchor
the base of the stand to the wall.
Multiple thread cabinets are designed to be stacked together to
create a larger storage unit. To stack two units, insert 4x dowels
in the top of one cabinet and then carefully position the base of
another cabinet over the top. Ensure both cabinets are
independently affixed to a wall or desk - the stacking dowels are
designed only to provide alignment, they will not prevent the
cabinets from toppling.
Need assistance? Call us at (800) 428-7606
Insert all 7 finished drawers into the cabinet. If desired,
apply the included stickers to the front face of each drawer
to organise your Hemingworth threads. The stickers may
need to be trimmed to size. Note that it is normal to have
spare parts left over (dowels, screws, etc).
Your cabinet is now complete!
Made in China
Distributed by:
Embroidery Central
1638 North 200 West
Logan, UT 84341
www.embroidery.com
Ensure the runner is
firmly up against the front
and side of the drawer.
If the cabinet is placed on a desk, the included safety bracket
should be used to attach it securely to either the desk surface or
a wall behind the cabinet as shown.
Attach the back, side or top of
the cabinet to a desk or wall
Note position of
angled edge
Min. 21cm clearance
from bottom edge
Min. 60cm clearance
from bottom edge
