18
Chapter 2: Installation
Pole Mount
Keep the following in mind when using a pole mount:
•
Thread type of the four mounting holes is 1" thread, 0.9" depth
•
Hand tighten until snug (do not overtighten)
•
Use the set screws on the long sides of the base (see middle
drawing in Figure 2-6 on page 13) to secure the V102 in place (3/16"
Allen wrench not included)
Overtightening may damage the system. This is not covered
under warranty.
Before pole mounting the V102
•
Decide if you need the roll measurement. If you need roll
measurement, the V102 will need to be installed perpendicular to
the vessel axis. If it you do not need roll measurement, install the
V102 parallel with the vessel’s axis.
•
Choose a location that meets the mounting location requirements.
•
Mark and drill the mounting holes as necessary for the threaded
pole.
•
Attach the power/data cable to the cable clamp and attach the clamp
to the bottom of the V102 using the screw and washer. Do not fully
tighten the screw so you can adjust the cable as necessary when
attaching the cable end to the port on the V102 (see “Connecting the
Summary of Contents for V102 G
