Henden Salt and Mineral Chlorinator Owners Manual
HENDEN
INSTALLATION & OWNERS MANUAL
|
11
OWNERS MANUAL
2. OPERATION OF YOUR HSMC
CHLORINE OUTPUT is expressed as a percentage of the maximum output of the HSMC. Set the HSMC to the percentage
output required and the unit will automatically adjust the cell output to the set level. The HSMC is fitted with an electronic
control and warning system. This regulates the output of the HSMC to the pre-set maximum and changes cell polarity as
indicated by the “+” or “–” on the digital display. The polarity will alternate over a number of hours of chlorination time, not
necessarily pump-run hours.
3. CONTROL PANEL
3.1 Layout
100% – 09:29 AM
auto ON
Figure 3.1
Manual on/off
Menu up/down
Menu/setting select
Menu/setting cancel (go back)
Power indicator
(lit when HSMC on)
Alarm indicator
(flashes when alarm active)
Time out
(whenever device is left for 30 seconds without
input from user, settings are saved, and home
screen displayed)
4. INITIAL START-UP
Once the salt level in the pool is correct the unit may be switched on (refer to page 9).
Note: Once the unit starts there is a short time delay until the cell operates to ensure the filtration system
is primed with water.
• The first time the Henden Salt and Mineral Chlorinator is turned on, the following screen is shown on start-up:
HENDEN
V1.2.7 AU 15L
Figure 4.1
> This screen shows the version of software (ie v1.27 shown) and your model of HSMC (ie AU 15 shown, meaning HSMC15).
