Hendi 230602 User Manual Download

Page: 10 / 100

NOTE!

Due to manufacturing residues, the appliance may

emit a light odor during the first few uses. This is normal and
does not indicate any defect or hazard. Make sure the appli-
ance is well ventilated.

Installation

• Read this manual thoroughly and carefully before installa-

tion and operation.

• Ensure the machine is placed in a dry area and that the

surface has sufficient strength to support the appliance.
Also ensure that there are no obstructions nearby during
operation of the appliance.

• Ensure that the electrical power supply corresponds with

the rating label on the machine.

CAUTION! Never

bypass any safety micro switch.

Operating instructions

Note:

For safety reason, the appliance can only start to oper-

ate with the jug set (6) installed properly on the motor unit (5)
and when the protective cover (10) is closed properly.
• Check if the power switch (1) is at the “0” position and turn

the speed dial (2) to “Low” position.

• Unplug the machine and open the protective cover (10), take

out the jug set (7) from the motor unit (5).

• Pour all the ingredients into the jug (7) and close the lid (8)

and place the cover cap (9) correctly in place.

• Place the whole jug set (7) onto the motor unit (5) & close

the protective cover (10).

• Connect the power plug to a suitable electrical power supply

socket.

• Switch ON the machine by pressing the power switch (1) to

“I” position & select a suitable speed by turning the speed
dial (2).

Speed dial (2) setting

Description

Low speed

For mixing liquids

High speed

For mixing liquids and solid

ingredients

Pulse function (0 / II)

For ice crushing or short,

power impulse movements.

Note: Use the pulse func-

tion for 1 ~ 2 seconds each

time. Repeated about several

times if necessary.

After use, always turn the power switch (1) to “0” position and
disconnect the plug from the electrical socket.
Remarks:
1. For the best results when blending solid foodstuffs, only

add small portions in succession, not all ingredients at the
same time.

2. Always start with lower speed. If necessary, then switch to

the higher speed or to the “Pulse” function, so as not to jam
the blade assembly (6).

3. Do not use this machine to blend hard foodstuff, such as

nuts.

4. Do not fill liquids above the

MAX.

mark of the jug (7).

5. Liquids to be blend should be at or below room temper-

ature. If you are going to blend warm liquids, ensure that
the jug lid (8) is correctly in place and use low speed for
processing. Risk of burns and be careful.

6. Avoid long period of operation due to the loud noise that

may hurt the hearing.

Special safety features
IMPORTANT:

This machine has a specially designed safety

feature: Protective cover (10).
The machine can only operate when the protective cover (10)
is closed and the jug (7) is installed properly on the motor unit
(5).

Cleaning & maintenance

•

ATTENTION!

Always disconnect the appliance from the

power supply and cool down before storage, cleaning &
maintenance.

• Do not use water jet or steam cleaner for cleaning and do

not push the appliance under the water as the parts will get
wet and electric shock might be resulted.

• If the appliance is not kept in a good state of cleanliness, this

can adversely affect the life of the appliance and result in a
dangerous situation.

• Food residues should be regularly cleaned and removed

from the appliance. If the appliance is not cleaned proper-
ly, it will reduce its lifespan and may result in a dangerous
condition during use.

•

DANGER OF INJURY!

Care should be taken when handling

the sharp cutting blades during cleaning.

Cleaning

• Clean the cooled exterior surface with a cloth or sponge

slightly dampened with a mild soap solution.

• For reasons of hygiene, the appliance should be cleaned

before and after use.

• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or

cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!

• No parts are dishwasher safe.

Maintenance

• Check the operation of the appliance regularly to prevent

serious accidents.

• If you see that the appliance is not working properly or that

there is a problem, stop using it, switch it off and contact
the supplier.

• All maintenance, installation and repair work must be car-

ried out by specialised and authorised technicians, or rec-
ommended by the manufacturer.

Transportation and Storage

• Before storage, always make sure that the appliance has

been disconnected from the power supply and completely
cooled down.

• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could