5
EN
2. DISHWASHER CONNECTION
If you are utilizing a dishwasher, complete the fol-
lowing procedure. If dishwasher is not to be con-
nected go on to section 3.
A. Using a blunt instrument (steel punch or wood-
en dowel), knock out entire plug (see 2A). Do not
use a screwdriver or sharp instrument. (When
knockout plug falls into disposer, you may re-
move it or grind it up when the disposer is used.
This will not damage the disposer in any way, but
may take some time to grind).
B. Connect dishwasher hose (see 2B) using hose
clamp. Make sure all plumbing connections are
tight and in accordance with all plumbing codes
and ordinances. Run water and check for leaks.
* Air gap may not be required for all installations.
Check local plumbing codes.
air gap
knock out plug
2B
2A
rubber hose
wood or metal
dowel
dishwasher hose
drain
disposer
3. INSTALLATION OF MOUNTING ASSEMBLY
READ COMPLETELY BEFORE STARTING
NOTE:
Pay close attention to the order of mount
assembly parts, as they have been correctly as-
sembled by the factory (see 3A). Also, reference
the cushion mount detail in illustration 3G for the
proper position of the cushion mount.
NOTE:
Try practicing this assembly before you get
under the sink to get the “feel” of how the parts fi t
together.
A. Disassemble mount assembly from disposer by
turning mount ring to the left (clockwise) and
remove.
SPEED MASTER MOUNT SYSTEM
B. Raise mount ring toward top of sink fl ange.
Remove cushion mount. Remove mount ring.
You may want to practice installing the cushion
mount at this point before you are under the
sink. See paragraph H. Also see the “Important
Notice: Cushion Mount Detail.”
C. Unscrew support ring from sink fl ange and re-
move fi ber gasket. You are now left with sink
fl ange and rubber gasket.
removeable
splash guard
3
sink fl ange
fi ber gasket
support ring
cushion mount
sink fl ange
gasket
