62
INSTRUCȚIUNI DE UTILIZARE
I. Realizarea unei pungi dintr-o rolă de pungi
1. Conectați unitatea la sursa de alimentare; Rotiți comutatorul la “I”.
2. Deschideți capacul superior.
3. Asigurați-vă că tăietorul de pungi se află la capătul raftului, apoi puneți raftul în spate. – Fig. 1
Fig. 1
Fig. 2
Fig. 3
4. Scoateți punga atunci când are dimensiunile dorite. – Fig. 2
5. Puneți jos raftul tăietorului și asigurați-vă că se află în locul potrivit pentru pungi, apoi glisați
tăietorul de la un capăt la celălalt, pentru a tăia punga. – Fig. 3
6. Puneți un capăt al pungii pe partea superioară a benzii de etanșare, fără a-l introduce în camera
de vidare. – Fig. 4
Fig. 4
Fig. 5
Fig. 6
7. Închideți capacul superior și apăsați ferm până când auziți
clicul de poziționare la ambele capete. – Fig. 5
8. Apăsați „Etanșare manuală” pentru a porni procesul de etan-
șare a pungilor. – Fig. 6
9. Ridicați mânerul frontal pentru a deschide capacul și scoa-
teți punga din mașină. Punga este realizată acum și este gata
pentru etanșare. – Fig. 7
II. Ambalarea în vid într-o pungă
1. Puneți produsele într-o pungă. Folosiți numai pungile vid special destinate și furnizate de noi
împreună cu canalele de vidare.
2. Curățați și îndreptați capătul deschis al pungii și asigurați-vă că nu există praf sau cută.
3. Puneți capătul deschis al pungii în zona camerei de vidare. Asigurați-vă că orificiul admisei de
aer nu este blocat de pungă. – Fig. 1
4. Puneți jos capacul și apăsați mânerul frontal pentru a-l închide. – Fig. 2
5. Verificați starea LED-ului „timp de vidare” și „etanșare” pentru a confirma acest timp în funcție
de starea umidității din produsele ambalate (extinsă/ umedă/ uscată) și presiunea de vidare
dorită (normală/moderată) corespunzătoare tipului de alimente;
Fig. 7