Intelligence Aided Lifting Equipment
26
maximum speed in each stage is the number of stages × 10% of the maximum speed. The user
may set the maximum operating speed in the mode of manual hold through the speed setting in the
menu according to the demand. Specific methods of operation are as follows:
1.
When the main interface displays “lock mode”, click the “ENT” button to enter the main
menu interface.
2.
Use “UP” and “DOWN” to select “Speed Up/Down Adjustment” and click the “ENT”
button to enter its menu.
3.
Select “Speed Settings” → “Manual Speed Settings”, select the desired level with “UP”
and “DOWN” and confirm with the “ENT” key.
4.
Press the “ENT” button to exit to the main interface. The maximum operating speed
setting in the mode of manual hold is completed.
4.1.4 No-load deceleration function
In practical applications, the operator always expects the load to run stably at a slower speed
from the worktable (pallet, floor) and then return to a higher operating speed. The no-load
deceleration function provides a period of deceleration when the equipment is lifting the load.
When the equipment is lifting the load, the no-load deceleration function will determine
whether it is necessary to perform deceleration operation according to the comparison of the
current load weight value and the preset no-load weight threshold. Where the current load weight
value is less than the preset no-load weight threshold, the equipment will run at the speed stage in
the no-load speed adjustment for the duration in the no-load speed time limit setting, and then
resume to the normal operating speed. If it is within the no-load speed time limit, when the current
load weight value changes are no less than the preset no-load weight threshold, the speed will
return to normal operating speed. When the current load weight value is larger than or equal to the
preset no-load weight threshold, the equipment performs no deceleration function.
Note:
The no-load operating speed can be set as larger than that in a normal operation.
4.1.4.1
Usage mode
1.
When the main interface displays “locking mode”, click the "ENT" button to enter the
main menu interface.
2.
Select "Lifting Speed Adjustment"
→
"No-load Speed Setting" and click the "ENT"
button to enter its menu.
3.
Enter the "No-load Speed Switch" menu, select "Open" through the "UP" and "DOWN"
buttons, and click the "ENT" button for confirmation and saving.
4.
Enter the "No Load Weight Threshold" menu and click the "ENT" button to set the
no-load weight threshold (the set value should be slightly smaller than the lifting load weight);
