Intelligence Aided Lifting Equipment
31
set at the top, it will lose its effect.
5.
If the slowdown point is set to reduce the impact of load docking in the air, you must
ensure that the load is set at the slowdown point before the docking point and the slowdown
point must be at least 10 cm away from the docking point.
6.
The soft limit configuration has a separate reset function. In the corresponding function
interface, click the “UP” button to select “invalid” and then press the exit button “ESC” and
the separate reset is done.
7.
Soft limit is configured with “Reset soft limit” menu, select reset, all soft limit resets are
“invalid”.
8.
The deceleration speed in soft limit is 1.8 m/min.
4.7 Inching button operation
Only the qualified personnel can use the inching button when changing steel wire ropes.
Effective use of inching button must require the equipment to be normally energized. The inching
button may be used as follows:
1.
Press the button A (self-locking), buttons B, C (Fig. 4 3) and then the operation works.
2.
Pressing the upward inching button B (self-recovery) will start the motor and cause the
system to roll the wire rope onto the drum.
3.
Pressing the downward inching button C (self-recovery) will start the motor and cause
the system to roll the wire rope down from the drum.
Note:
When the wire rope is replaced, the wire rope must always be perpendicular to the wire rope
jacket mouth whether it is rolled in or rolled out.
When the wire rope is replaced, the wire rope must be under tension (greater than 50N).
For detailed steps, please see the “Instructions on Wire Rope Replacement” and the
video named “Replacement Of Steel Wire Ropes” for reference.
Fig. 4 3 Inching button
