Intelligence Aided Lifting Equipment
39
3.
If manual mode is used for dual-suspension, the system will automatically enter the
fixture work piece suspension state or fixture suspension state according to the received
clamp/release feedback signal.
4.
When the system receives the clamping feedback signal, it automatically switches into
the fixture work piece suspension state.
5.
When the system receives the releasing feedback signal, it automatically switches into
the fixture suspension state.
5.4.4
Protection settings for dual suspension
The dual suspension function can provide the position protection function, as the user can set
the function within the specific position range, and then the dual suspension switching can be
effective. After the setting is completed, the system is only allowed to be switched to "fixture work
piece” suspension when it is set between the “low seizing position” and the “high seizing position”,
and can be switched to “fixture” suspension when it is set between “low unload position” and
“high unload position”.
Setting method:
1.
Enter the “Extended Function Settings”
→
“Dual Suspension Setting”
→
“Dual
Suspension Protection”
→
“Protection Switch” submenu, select “Open” and then click
“ENT” to return to the previous menu.
2.
In the clamping station, set values for “low seizing position” and the “high seizing
position” in the “dual suspension protection” menu according to the actual situation.
3.
Same as above, set values for the “high unloading position" and "low unloading
position" in the unloading position.
5.4.4.1
Functional instructions
1.
The protection function is only valid for single (dual) signals, and the position protection
function is invalid when using the "fixture signal";
2.
When dual-suspension protection is set, then the user is only allowed to switch to the
“fixture weight” suspension state when the load position is between “high unloading
position” and “low unloading position”; while the user is only allowed switch to the
“fixture work piece weight” suspension when the load position is between “high seizing
position” and “low seizing position”. For other positions, the user is not allowed to
perform the switching operation to suspension state.
5.5 Anti-drop function
The anti-drop function can prevent the user from accidentally pressing the clamp release
button during the movement of heavy objects, resulting in heavy objects falling and causing
