Intelligence Aided Lifting Equipment
44
5.8 Wireless Remote Control Module
Accessing the Henghui wireless remote control module through the host expansion port to
operate the device via a wireless remote control handle.
The wireless remote controller can achieve the following functions: (1) Slow gear
downwards, (2) Slow gear upwards, (3) Fast gear downwards, (4) Fast gear upwards, (5) Switch to
suspension, (6) Switch to suspension unloading, and (7) Switch to unloading.
The Henghui wireless remote control module is fixed on the host shell and is connected to the
dedicated cable on the host extension interface. The wireless module can be turned on and off
through the wireless remote controller.
The wireless (handle) module needs to be used with a coaxial handle (stepless handle), and
the coaxial handle (stepless handle) is the priority for operation.
5.8.1
Operation methods for the wireless remote control
1.
Install the wireless remote control module to the equipment and connect it to the power
supply;
2. Enter the "Service" interface, then enter the “Wireless Switch” manual and select “Open”
option, and then click “ENT” button to save the setting.
3.
Restart main power supply of the equipment;
4.
Put the security block of the wireless remote controller into the card slot, and then press
the “On” button;
5.
At this point, you can operate the wireless remote controller to control the equipment
operation.
5.9 Expansion interface
Henghui intelligent lifting equipment provides three kinds of extension interfaces, namely:
Host extension interface, handle extension interface, and external expansion module interface.
5.9.1
Host extension interface
The host extension interface provides 3-route output and 8-route input signals. (Among
which, three output routes are temporarily reserved.)
