- 57 -
screen.
When all channels under a group display combination are closed, it
means that this group display combination is not opened.
5.10 Control configuration
Move the cursor to the [Control] entry in the [Configuration] screen and
press [Confirm] to enter [Control Configuration], the screen is introduced as
shown in the figure.
①
Loop serial number:
The channel serial number of the control loop,
limited by configuration, up to 4 channels.
②
Loop status:
Select the channel working status.
③
Setting value SV:
Select the source and value of the setting value.
④
Sampling value PV:
Select the signal source of the sampled
measurement value.
⑤
Output value MV:
Set the upper and lower limit values of the loop
output.
⑥
MV preset value:
Set the initial value of MV at cold start.
Summary of Contents for HT R71
Page 22: ... 22 4 2 Usage Patterns ...