Item number: 2-539-198, Version: 3 241016TK 13 of 20
EN
1. Introduction
These installation instructions are provided for the connection and starting procedure of your
shaft encoder.
This encoder is EX - tested and licensed according to ATEX and IECEx. On request, we will be
pleased to send you the respective EC-TYPE-Examination Certificate.
For information concerning interfacing please refer to the Technical Manual SSI/BISS.
(See www.hengstler.de)
You will get further information on request.
Compliance with all of the security information and procedural instructions is essential to en-
sure work safety.
German is the original version.
2. General
2.1. Explanation of symbols / Warnings
Symbols are used to denote warnings in these operating instructions. These warnings are introduced
by signal words that describe the magnitude of the risk. Observance of these warnings is absolutely
compulsory, and due caution must be exercised at all times to prevent accidents, injury and property
damage.
Warning!
Indicates a possibly dangerous situation that can result in death or severe injury
if not avoided.
Caution!
Indicates a possibly dangerous situation that can result in minor injury if not
avoided.
Note!
Indicates a possibly dangerous situation that can result in property or environment
damage if not avoided.
Tips and recommendations!
Highlights useful tips and recommendation, together with information for efficient,
trouble-free operation.
