2 735 061, Rev. 030798
Operating Instructions tico 735 - Elapsed Timer
page 6/12
Operation Mode
Changing a Preset value (example)
Default display is the present
time value.
/DE!
Pressing the Program Key will
cause the display description to
appear on the main display.* If
there is no key activity for 3
seconds, the primary display will
switch back to the count value.
-!/
Continued pressing of the
Program Key will scroll to the Set
Value. (see parameter sequence
below.) The full parameter
description will appear on the
main display.*
O
To change the Set value, press
the Scroll Key. If there was no
key activity for 3 seconds, the Set
value will appear (one digit
description shown on secondary
display); however, press the
Scroll Key in order to edit. The
unit will now be in Edit Operation
as signified by the most
significant digit flashing.**
P
,
Use the Scroll Key to move from
left to right and highlight the digit
that needs to be changed. Wrap
around will occur from the least
significant to the most significant
digit.
O
,
Use the Down Key to decrement
the digit until the desired value
appears. The display will wrap
around from 0 to 9.
-!/
After the desired digits have been
changed, press the Program Key
to enter the new value. The new
value will appear on the main
display without any flashing
digits. Press the Program Key
again and the parameter
description will appear on the
main display.
* Parameter descriptions will not appear on the
primary display if the „Help“ function has been
disabled
** Edit Operation cannot be accessed if the Preset
Lock has been enabled in Program Mode
Display Parameter Sequence
/DE!
Time Value
Function: Displays the present
time value.
Adjustement Range:
0 to 99999
,!/
,
Set value
Function: Defines the value at
which output 1 will be activated
Adjustment Range: 0 to 99999
Default Value: 0
