Hengx CYD-C8+-15K, Manual

16

9. Troubleshooting and Error message   

Appendix 1 BIRCH/GODEX/ZEBRA/GP printing format 

Prt-01                                 Prt-02 

Prt-03 

Error 
Message 

Problem Solution 

ERR0 

Exceed the zero range 

The item on the pan should be within 2% of 
full load. 

ERR1 

Model setting error. Resolution 
should be within 300-300000 

Adjust or reset the capacity first then adjust 
resolution 

ERR2 

Initial zero point exceeds 30% of full 
load  

1.Remove the obstacle article under the pan
2.Replace the load cell or contact the 
maintenance department. 

ERR3 

Exceed the A/D resolution range 

1. Replace A/D 
2..Replace the load cell or contact the 
maintenance department. 

ERR4 

EEPROM Chksum failure 

Re-weld EEPROM or contact the 
maintenance department. 

ERR5 

Overload condition 

Remove the overload item 

ERR6 

Exceeds the display range 

----------------------------------------------- 

ERR7 

Accumulated number of 

weighments exceeds the display 

range 

Delete the exceeding weights 

ERR8 

Weight limit value is higher than the 
full load value 

Reset the weight limit value. 

ERR9 

Exceed tare or pre-tare range   

0

＜

Tare value

≤

 full load 

ERR10 

Wrong calibration weights 

Place the right test weights and the 
calibration value should be below full load. 

N.W.:   0.500   kg 
U.W.:   0.0500  kg/pcs 
Total:     10pcs 

0.500 kg

10 pcs