4 of 12
Instruction handbook
Version 1.0 · 23.12.17
EN
All safety regulations must be complied with; the
manufacturer is not liable for any damage resulting
from non-observance of safety regulations!
WARNING Risk of injury due to incor-
rect use, not wearing the personal pro-
tection equipment.
During use all users and all persons in the vicinity
must wear a protective mask with P2-filter*, overall*,
protective goggles, ear protection and safety gloves to
prevent inhalation of the fumes and skin contact with
the dispensed material.
The user is not permitted to point the mix tip at liv-
ing beings or objects during use.
Observe the safety instructions on the cartridge
WARNING Explosion and fire hazard
Never use the dispenser to spray on
open fire.
Never use the device near sources of
ignition or energy sources that constitute a
potential risk of combustion/explosion.
WARNING Risk of tripping over the
compressed air hose / due to lack of
cleanliness at the workplace!
Always ensure that the workplace is clean and tidy.
Lay compressed air hoses so that they do not cre-
ate a tripping hazard for the operator or bystanders.
• Only use the device when it is in a technically perfect
condition in accordance with its intended purpose
and in compliance with all safety regulations.
• In the event of defects or operational faults, stop op-
eration of the device immediately, remedy the faults
if possible and inform the manufacturer.
• The pneumatic driving unit of the dispenser may
never be opened or removed.
• Dispensers weighing more than 5kg must be carried
with a shoulder strap.
• The dispenser must be handled carefully and stored
at a cool, dry place. The device must be transported
carefully. Shocks should be avoided as far as possi-
ble. Never drop the dispenser onto the floor or work-
bench. Prevent knocks at the workplace.
• It is not permitted to remove, circumvent, bridge or
take the safety devices out of operation when the
device is in use.
• Always comply with the warning and information
signs on the device. These warning and information
signs should never be removed. They must be re-
placed immediately if they become detached or are
illegible, see "4) Product overview" on page 6
• Pressure limits must be strictly adhered to.
• Before usage, always check the dispenser for any
visible signs of damage and faults. Only use the dis-
penser when it is in usable condition. If you are un-
sure of the usability of the device or if signs of
breakage or other damage become recognizable,
stop using the device immediately. Send the device
to an authorized agent of the manufacturer for in-
spection and repair (refer to the address list at the
back).
• Always keep the dispenser clean to prevent func-
tional fault or injury.
• Never attempt to make any repairs or modifications
to the device yourself. Maintenance and repairs
must be carried out exclusively by qualified special-
ist personnel. This work may never be carried out
when the dispenser is connected to the compressed
air supply.
• Always ensure that the workplace is safe.
• Take care when connecting and removing com-
pressed air hoses. Ensure that the air hoses are laid
so that you or other persons do not become tangled
in the hoses or can trip over them.
• Only original spare parts of Henkel may be used.
When using spare parts of other manufacturers, all
warranty rights towards the manufacturer are ren-
dered invalid and malfunctions or accidents may oc-
cur.
Manipulations or modifications to the device by
persons not authorized by the manufacturer as
well as non-compliance with the safety regula-
tions contained in the instruction handbook are
dangerous and can cause accidents with serious
injury and/or damage to materials.
