12
6
Application Hints
As with all adhesives, performance depends on conditions of use. Suggestions or
recommendations contained herein are for guidance only since actual conditions of
use are outside the supplier’s control.
6.1 Shutdown for Longer Periods of Non-use (>recommended idle time)
•
Disconnect the pneumatic supply from the unit.
•
Clean the product hose and dispensing valve.
Recommended maximum idle times for different products are shown below:
Adhesive
Maximum idle time for dispensing Systems
Anaerobic
2 weeks
Cyanoacrylate
1 week
UV-acrylate
2 weeks
Acrylate
1 week
Epoxy
2 weeks
Activator
n.a.
Primer
n.a.
6.2 Returning to Operation after Longer Periods of Non-use
•
Reconnect the pneumatic supply to the unit.
•
Check the installation according to Chapter 4.
•
Return to operation according to Section 5.1.
