Technical Process Bulletin
BONDERITE C-AK 9045-6 AERO
WATER BASE CARBON REMOVER
(KNOWN AS TURCO 9045-6)
1 of 3
INTRODUCTION:
BONDERITE C-AK 9045-6 AERO (known as TURCO 9045-6) is a unique water base carbon remover used to remove
carbon deposits and difficult to remove soils found in aircraft engines. It cleans engine blocks, pistons, carburetors,
transmissions, and brake assemblies. It is an effective carbon remover for jet engine overhaul. It may also remove some
paints.
FEATURES:
Approved
by
Pratt & Whitney
(SPOP 207)
Does not contain chlorinated hydrocarbons, phenols, or chromates
Safe on common engine alloys
Used as received. No mixing or dilution required
Operates at moderate temperatures, 40º to 60ºC
Can be used in Turbulators, Ultrasonic systems or other mechanically agitated tanks
Long
lasting
USE INSTRUCTIONS:
Equipment:
Tanks may be constructed of mild steel but preferably stainless steel.
1. Preclean parts using an alkaline cleaner or steam cleaner to remove oils, grease, and loose soils. This will
prolong
the tank life of BONDERITE C-AK 9045-6 AERO.
2. Water rinse after pre-cleaning. Do not use solvent rinse. Introduction of solvents in BONDERITE C-AK 9045-6 AERO
will decrease the carbon removing properties.
3. Immerse parts in BONDERITE C-AK 9045-6 AERO. Use light mechanical agitation to aid in carbon removing. Time
required is from 30 minutes to 2 hours depending on the contaminates to be removed.
4. The preferred temperatures are 40º to 60ºC. Do not exceed 60ºC.
Do not over heat
.
5. Remove parts and allow excess to drain back into tank.
6. Rinse with cold or hot water. High pressure rinsings is recommended.
7. Immerse parts in BONDERITE AQUASORB (WATER DISPLACING OIL) to prevent flash rusting of steel parts. Allow
parts to drain without rinsing.
