HENNESSY INDUSTRIES Coats 1185, Operation Instructions Manual

20 • 

Important: Always read and follow instructions.

Installation Instructions

A factory trained COATS

®

 Service Technician must 

perform the install, setup, and initial test procedures 

on your wheel balancer. Do not attempt to install and 

setup the unit yourself. Accurate and reliable opera-

tion of your unit depends on proper installation. Please 

con-tact COATS

®

 directly at 1-800-688-9240 for the 

Certified Service Partner nearest you.

Receiving

The shipment should be thoroughly inspected as 

soon as it is received. The signed bill of lading is 

acknowledgement, for the carrier, of receipt in good 

condition of the shipment covered by our invoice.

If any of the goods called for on this bill of lading 

are shorted or damaged, do not accept them until the 

car-rier makes a notation of the shorted or damaged 

goods on the freight bill. Do this for your own protec-

tion.

NOTIFY THE CARRIER AT ONCE if any hidden loss 

or damage is discovered after receipt and request him 

to make an inspection. If the carrier will not do so, pre-

pare an affidavit to the effect that you have so notified 

the carrier (on a certain date) and that he has failed to 

comply with your request.

IT IS DIFFICULT TO COLLECT FOR LOSS OR DAM-

AGE AFTER YOU HAVE GIVEN THE CARRIER A 

CLEAR RECEIPT.

File your claim with the carrier promptly. Support 

your claim with copies of the bill of lading, freight bill, 

invoice, and photographs, if possible.

Although COATS responsibility ceases upon delivery 

of the shipment to the carrier, we will gladly assist in 

tracing lost shipments. Our willingness to assist in 

every possible manner does not make COATS respon-

sible for collection of claims, or replacement of lost or 

damaged materials.

Standard Accessories

• Built-in Weight Tray
• 3 Back Cones (A, B, C)
• Truck Cone (D)
• Hub Nut
• Pressure Cup
• Rim Width Calipers

Features

• Balances Most Automotive Wheels
• Single-Spin Dynamic Two-Plane or Static Balancing
• Vertical Wheel Mounting
• Back Cone and Front Cone Mounting
• “No Bolt-Down” Installation
• Scratch Resistant Control Panel
• Easy-To-Read LEDs and Displays
• Automatic Calibration
• Removable Shaft Stud
• Automatic Rim Gauge Return
• Dynamic, Static, and Alloy Operating Modes

Specifications

• Weight (excluding adapter) ...................... 130 lbs.
• Single-phase power supply ....115V, 50/60 Hz, 3A
• Protection class ........................................... IP 54
• Max power consumption ..........................0.8 Kw
• Balancing speed ....................................100 rpm

-1

• Cycle time for average wheel (14 kg) 6-8 seconds
• Max.resolution of measurement .............. 0.10 oz
• Position resolution ..................................... ± 1.4 °
• Average noise ..................................... < 70dB (A)
• Rim-machine distance 0 - 252 mm
• Rim width setting range 1.5 to 20 inches
• Diameter setting range 10 to 30 inches

Electrical Requirements

See serial tag for the appropriate power require-

ments of your machine.

Always have a qualified electrician install the proper 

receptacles in accordance with state and local codes.