Important: Always read and follow instructions.
• 21
Floor and Space Requirements
The balancer must be located on a flat floor of solid
construction, preferably concrete. The balancer must
sit solidly on its three feet. If the balancer is not level,
does not sit solidly on its three feet, or is placed on an
unstable floor, the balancer will not function properly
and may produce inaccurate balance readings.
Do not operate the balancer while it is on the pallet.
Select a location for the balancer that provides a
level, solid floor, and adequate clearance around and
above the balancer. Make sure the location selected
has enough room above and behind the unit so the
hood can be raised completely. The location must also
pro-vide working room for mounting and removing
wheels. Make sure the area has adequate lighting
Space Requirements
6
1006
mm
470
mm
1219
mm
1329
mm
939
mm
ENGLISH
Use and maintenance manual
Machine description
It is used to balance the wheels of cars, vans, 4-WD, motorcycles and scooters. The wheels must weigh less than 75
kg. and, when fitted on the balancing machine, must not interfere with any fixed part of the machine, excluding
the shaft and support adaptor.
The machine is supplied with equipment enabling the vast majority of car wheels
available on the market to be fitted. Other wheels with special dimensions, geKometry and centring require special
adaptors supplied on request (consult the attached sheet “
ORIGINAL ADAPTORS
”). The machine can operate only
on flat non resilient floor.
Do not mount anything other than motorbike, car or truck tyres on the wheel balancer.
Thanks to the new and exclusive VDD (Virtual Direct Drive) system, reliable unbalance measurements can be made in
a short time, almost half the time of the cycle used with respect to other balancers in this range.
2.1
TECHNICAL SPECIFICATIONS
The following data refers to the balancer in its standard
configuration.
Single-phase power supply
115 / 230 V 50/60 Hz
Protection class
IP 54
Rated power
0,15 kW
Balancing speed
100
min
-1
Cycle time for wheel
4.7 s (5 3/4”x14”) 15 kg
Measurement uncertainty
0,5 g
Average noise
< 70 dB (A)
Rim width setting range
1.5” ÷ 20” or 40 ÷ 510 mm
Diameter setting range
10” ÷ 30” or 265 ÷ 765 mm
Maximum wheel weight
< 75 kg
Machine weight
110 kg
2. Machine description
2.3
COMPONENTS
TOUCH CONTROL PANEL
WEIGHT-TOOL HOLDER
AUTOMATIC GAUGE
2.2
DIMENSIONS
39.5 inches
(1006 mm)
18.5 inches
(470 mm)
40 inches
(939 mm)
48 inches
(1219 mm)
52.3 inches
(1329 mm)
Summary of Contents for Coats 1185
Page 29: ...Important Always read and follow instructions 23 Notes...
Page 30: ...24 Important Always read and follow instructions Notes...
Page 31: ...Important Always read and follow instructions 25 Notes...
Page 32: ...85611754 00 08 20 Copyright 2020 Hennessy Industries LLC All Rights Reserved Printed in USA...
