22 •
Important: Always read and follow instructions.
Unpacking the Unit
1.
Remove the shipping carton from the pallet. Fig.
1
2.
Remove all loose parts and accessories packed
around the unit. Remove Balancer from Pallet
3.
Remove the shipping bolts that hold the balancer
to the pallet.
CAUTION
Do not use the control panel, control panel
base, accessory storage, faceplate, hood or
shaft to lift the balancer.
CAUTION
Use help to remove the balancer from the
pallet. The unit is heavy and the weight is
not evenly distributed. Dropping the unit
may cause personal injury or equipment
damage.
4.
Lift the balancer off the pallet and place it in its
operating location.
Hood Installation
5.
Remove one screw holding the Hood bracket to
the balancer arm. Fig. 2
6.
Align the Hood bracket with the balancer arm and
secure with three screws. Fig. 3 & 4
Connect to Power
Your factory trained COATS
®
Service Technician
should do the final check to verify the power installa-
tion before connecting the balancer to a power supply.
Failure due to improper power connection may void
the warranty.
Initial Testing
1.
Plug the unit into an appropriate power outlet. If
the circuit breaker for the outlet is off, turn it on.
2.
Turn the balancer on. The power switch is on the
back of the unit.
3.
Test the hood switch with the auto spin feature
to ensure proper installation. If problems check the
height of the hood switch button for proper operation
Summary of Contents for Coats 1185
Page 29: ...Important Always read and follow instructions 23 Notes...
Page 30: ...24 Important Always read and follow instructions Notes...
Page 31: ...Important Always read and follow instructions 25 Notes...
Page 32: ...85611754 00 08 20 Copyright 2020 Hennessy Industries LLC All Rights Reserved Printed in USA...
