Important: Always read and follow the on-screen operating instructions.
• 41
G
Gllo
os
ss
sa
ar
ry
y o
of
f T
Te
er
rm
ms
s
BDC -
an acronym for bottom-dead-center, also
referred to as the 6 o’clock position.
Dynamic Balance -
balancing a wheel using two
planes for correction. Dynamic balance means the
wheel is in balance when in motion about its rotational
axis. Also, a wheel is statically balanced when dynam-
ically balanced. However, a wheel that is statically bal-
anced is not necessarily dynamically balanced.
Hub Centric -
refers to mounting and means the
wheel is centered to the vehicle by the center hole on
the wheel and the pilot on the vehicle axle. The maxi-
mum clearance between the wheel’s center hole or
bore and the axle pilot is between 0.0015 and 0.006
normally.
Inner Plane -
the closest corrective weight location
from the balancer.
Lug Centric -
refers to mounting and means the
wheel is centered by the studs and nuts mounted on
the axle of the vehicle. This is the least desirable way
to mount a wheel; very difficult to maintain the wheel
centering on the vehicle axle.
Offset Arm -
pivoting arm that measures A & D
wheel dimensions.
A
- distance measured from the balancer
(“0” on the offset arm) to the inner plane of
the rim (inner weight location).
D
- diameter of the wheel at the weight
location, which is not always the same as
the bead seat diameter that determines tire
diameter.
W
- width between the inner and outer
planes.
Outer Plane -
farthest corrective weight location
from the balancer.
Static Balance -
balancing a wheel with only a single
corrective weight or splitting two weights at the same
radial location.
TDC -
an acronym for top-dead-center, also referred
to as the 12 o’clock position.
Weight Planes -
the location for corrective weights.
Video Balancer
