Model 290
Replacement
1. Drain the shortening.
2. Remove the high limit bulb holder from the heating
element inside the frypot.
3. Disconnect the heating element wires from the contactors.
Label each so it can be replaced in the same position on the
new element.
4. Remove the heat contactor, as described in Contactors Section,
to access the left side element nuts.
5. Loosen the screws on the element spreaders.
6. Slide the element spreaders to the center of the heating element.
7. Using a 7/8” crowsfoot, remove the brass nuts and washers
which secure the ends of the elements through the frypot wall.
8. Remove the heating elements from the frypot as a group by
lifting the far end, and sliding them up and out towards the rear
of the frypot.
Always install new rubber O rings (2) when installing heating
elements.
9. Install new heating elements with new rubber O-rings
mounted on terminal ends, and spreaders loosely
mounted in the center of the stacked elements.
10. Replace the heating elements, terminal end first at
approximately 45º angle, slipping the terminal ends through the
front wall of the frypot.
2-11
1103
2-10. HEATING ELEMENTS
(Continued)
Summary of Contents for OFE-290
