67
8
8))
Press the program button to move to the next timer period, M-F 2.
9
9))
Repeat steps 5, 6, 7, and 8 for all of the following time periods:
M-F 1
XX:XX A XX
M-F 2
XX:XX A XX
M-F 3
XX:XX A XX
M-F 4
XX:XX A XX
SAT 1
XX:XX A XX
SAT 2
XX:XX A XX
SAT 3
XX:XX A XX
SAT 4
XX:XX A XX
SUN 1
XX:XX A XX
SUN 2
XX:XX A XX
SUN 3
XX:XX A XX
SUN 4
XX:XX A XX
6
6..3
3 C
Cllo
occkk S
Se
ett
1
1))
Press and hold the program button for 5 seconds until “LEVEL 2” “SP PROG"
“ENTER CODE” shows in the display.
2
2))
Press the program button again and “CLK SET” “ENTER CODE” flashes in the
left display.
3
3))
Enter code 1, 2, 3.
4
4))
“CS-1 ENTER DATE MM-DD-YY” flashes in the left display. Use the product
buttons to set the date in the right display.
5
5))
Press the right arrow and “CS-2 ENTER TIME” flashes in the left display and the
time flashes in the right display. Press the up or down arrow, or product buttons,
to change the time.
6
6))
Press the right arrow and “CS-2 ENTER TIME” flashes in the left display and
“AM” or “PM” flashes in the right display. Use the up or down arrow to choose
AM or PM.
7
7))
Press the right arrow and “CS-3 TIME FORMAT” flashes in the left display and
“12-HR” or “24-HR” shows in the right display. Use the up or down arrow to
choose a 12-hour time format or a 24-hour time format.
8
8))
Press the right arrow and “CS-4 DAYLIGHT SAVING TIME” flashes in the left
display. Use the up or down arrow to choose daylight saving time for your area:
1.OFF; 2.US (2007 & after); 3.EURO; or 4.FSA (US before 2007).
9
9))
Press and hold the program button to exit.
Summary of Contents for Wendy's Evolution Elite EEG-251
