LINE OUT
The LINE OUT is both channels, post-EQ and post-reverb, and provides a
balanced, low impedance signal for use with mixing boards, PA systems, or
recording.
HEADPHONE JACK
The HEADPHONE jack will defeat the main speaker (but not the extension
speaker output) and is post-EQ and post-reverb. CAUTION: Listening to
headphones at high volumes can cause permanent hearing loss.
EXTENSION SPEAKERS
A second speaker cabinet can be connected to the parallel EXTENSION
SPEAKER output, which will not disconnect the internal speaker. Any extension
cabinet must be a minimum of 8 ohms and able to handle over 100 watts. DO
NOT CONNECT OR DISCONNECT AN EXTENSION SPEAKER WHILE THE
AMPLIFIER IS ON.
POWER AND FUSES
The Bud is 120 watts and is factory set to either 115 volt or 230 volt power,
depending on the country to which it was originally shipped. The voltage can
be changed internally; please contact Henriksen, Inc. or your dealer for specific
instructions. 230 volt amps require a 1A 250V slow blow fuse. 115 volt amps
require a 1.6A 250V slow blow fuse.
FX LOOPS
The FX loops send the signal from the amp post-EQ and return it pre-reverb.
(FX Loop detail on page 5)
