• This lamp is designed to be fixed in new pools and/or pools with existing surface mounted
lamps that need replacement.
• This lamp is designed to be used only once. Should it become defective, repair is impossible,
and replacement is necessary.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up
of any electric components which have been inserted or handled at locations other than its
own premises.
16 Programs of RGB LED Bulbs
1. White: sun white
2. Red: one color red
3. Green: one color green
4. Blue: one color blue
5. Green-blue: fixed color green/blue
6. Red-green: fixed color red/green
7. Blue-red: fixed color blue-red
8. Evening sea: slow animation red/blue
9. Evening rivers: slow animation red/green
10. Riviera: slow animation green/blue
11. White: neutral white
12. Rainbow: slow animation blue/red/green
13. River of colors: program 12, followed by program 15
14. Disco: fast animation
15. Four seasons: slow animation in red/blue/green/violet
16. Party: fast animation
Installation
All lamps should be placed on the wall of the pool at approximately 700mm below the water
surface, in areas that are easily accessible from the upper edge of the pool.
•
It is highly recommended to use the underwater cable gland
•
All lamps should be installed on the same transformer and switch.
•
The lamp is supplied with cable of 2m, 4m, 6m, 10m, 16m or 20m according to the need of the
user, making it possible to install multiple lamps connected to a single junction box.
Dissemble the bracket from the back of the lamp. Place the bracket over the desired location,
mark the holes, drill the holes, insert the roll plugs, and fasten the bracket on the pool wall using
the stainless steel screws provided. Wind the cable behind the lamp, and then fasten the lamp
on the bracket.
I. Models HT001C-P-T, HT011C-P, HT002C-P-T
– Various types of installation
