Adding or Removing Remote Control
：
1.
Adding New Remote Control
：
Press and hold [REMOTE] until light is switched on.
Press any button on remote control, matching is successful if light is switched off
( 21 remote control match at the most).
2.
Remove All Remote Control
：
Press and hold [
REMOTE
]
，
for 10 second until l the light on processing board turns off, then
release button.
SAFETY WARNINGS
The persons who are in charge of installation should have the required qualifications for this type of work.
Avoid making contact with the electric voltage.
Comply with the current standards regarding accident prevention.
IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS, SPECIAL WIRING, SWIMMING
POOLS.
Any maintenance works must be performed with the 220V incoming wire disconnected or switched off at
the main supply.
Do not handle any electrical components with wet feet.
Wire Connected Drawing:
