2
1
Vorbereitung:
Sitzbank abnehmen, Blinkerkabel lösen, Blinker demontieren.
Den Nummerschildhalter demontieren. Blinkerkabel müssen nicht
verlängert werden, wenn diese auf kürzestem Weg verlegt werden.
Montage Halteadapter hinten:
Den Halteadapter zwischen Nummerschildhalter und Sockel der
Schlußleuchte montieren. Die großen Originalscheiben auf der
Rückseite des Kotflügels entfallen.
Fastening of the rear adapter:
between number plate holder and socket of the rear light.
The original big washers on the back of the fender are obsolete.
Preparing:
Dismantle seat, number plate holder and turn signals.
Disconnect cable before. Turn signal cable must not be extended,
if they are laid on the shortest path.
Lock it Kofferträger / Lock it side carrier
HONDA CB 1100 RS
ab Baujahr 2017 / from date of manufacture 2017
HONDA CB 1100 EX
ab Baujahr 2014 / from date of manufacture 2014
Artikel Nr.: / Item-no.:
650
989
00 02
chrom/chrome
Of course, the assembly requires a certain technical experience. If you are not sure how to execute a determined action,
you should ask your local distributor to do it. First, tighten all screws only loosely. After mounting all parts, the screws
should be tightened to the torque specified. This guarantees, that the product is mounted without tension. Observe
the tightening torques of the manufacturer! Control all screw connections after the assembling for tightness!
Die Voraussetzung für die Montage ist natürlich eine gewisse technische Erfahrung. Wenn Sie sich nicht sicher sind,
wie man eine bestimmte Arbeit ausführt, sollten Sie diese Ihrer Fachwerkstatt überlassen. Ziehen sie alle zugänglichen
Schrauben zuerst nur locker an. Nachdem alles montiert ist, werden die Schrauben dann auf das entsprechende
Anzugsmoment festgezogen. Dadurch wird sichergestellt, dass das Produkt spannungsfrei angebaut ist. Anzugsmomente
beachten! Nach der Montage alle Verschraubungen auf festen Sitz kontrollieren!
Ratsche/Ratchet
Verlängerung/extension
Set
BENÖTIGTE WERKZEUGE
TOOLS REQUIRED
WICHTIG
IMPORTANT
MONTAGEANLEITUNG
MOUNTING INSTRUCTIONS