Page 6
For technical questions, please call 1-888-866-5797.
Item 57249
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM FLYING
DEBRIS: Wear long pants, long sleeves and
protective footwear. Wear ANSI-approved safety
goggles, dust mask, hearing protectors, and gloves.
Charging Battery Pack
Charge Battery Pack according to the
instructions included with the 20 V Hercules
Battery Charger (both sold separately).
Operation
TO AVOID SERIOUS INJURY AND PROPERTY
DAMAGE: Inspect the area before using the Blower.
Remove all hard objects from work area. Do not
blow debris in the direction of people, animals or
property. Use both hands when operating Blower.
1. Assemble Blower in the desired configuration
according to the Assembly Instructions.
CAUTION! The Blower Tube helps prevent contact
with internal moving parts. To prevent injury, do
not use the Blower without the Tube attached.
Note:
Rake or sweep to loosen debris if necessary.
2. Make sure that the Trigger is in the off-position,
then slide the Battery Pack into slot on bottom
of Blower Handle until it clicks into place.
3. Hold Blower with both hands, with the
Tube several inches off the ground.
4. Adjust Speed Control Switch to desired
setting, then press and hold Trigger.
5. To lock Blower on for continuous operation, press
Trigger fully and hold, then press and hold the
Trigger Lock from the left or right. Release the
Trigger first and then the Trigger Lock. To release
the lock-on function, press the Trigger again.
6. Sweep from side to side.
7. Release Trigger when done.
8. When finished, to prevent accidents:
• Remove battery pack.
• Wipe external surfaces of the Appliance
with clean cloth. Store in a dry, indoor
area out of reach of children.
MAINTENANCE AND SERVICING
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Release Trigger of the appliance and
remove Battery Pack before performing
any procedure in this section.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise
or vibration occurs or damage is noted, have
the problem corrected before further use.
Cleaning, Maintenance,
and Lubrication
1.
BEFORE EACH USE,
inspect the general
condition of the Appliance. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2.
AFTER USE,
wipe external surfaces of the
Appliance with clean cloth. Store in a dry,
indoor area out of reach of children.
3.
Li-Ion BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
Do not short, incinerate or open battery.
4. All parts are permanently lubricated.
Do not use additional lubrication.
